毕业作品网站

 首 页 机械毕业设计 电子电气毕业设计 计算机毕业设计 土木工程毕业设计 视觉传达毕业设计 理工论文 文科论文 毕设资料 帮助中心 设计流程 
垫片
您现在所在的位置:首页 >>电子电气毕业设计 >> 文章内容
                 
垫片
   本站为毕业设计参考资料分享平台,资料使用与选题问题可咨询微信号:biyezuopinvvp QQ:1015083682   

电梯控制系统设计(单片机)

文章来源:www.biyezuopin.vip   发布者:毕业作品网站  
摘 要
 
随着我国经济的发展,城市中涌现出越来越多的高层建筑,而与之配套的电梯已成为人们日常生活中不可缺少的工具。同时,由于国家老龄化问题目益突出,低层住宅建筑(一般5层左右)同样也有使用电梯的要求。所以电梯控制的研究在现代社会有着很重要的作用,作为一名电专业的学生,这些正是自动化专业所学习的内容,又是自己的兴趣所在。为了以后更好的工作和更深入的理解基于单片机的电梯控制系统,所以选择了该课题。
本课题是五层乘客电梯的模拟控制系统,其主要具有如下功能:
1.两部电梯由一组按键控制,当有人按下按键时,空闲的那一部电梯作出响应,若两部电梯均处于空闲的状态,两部电梯同时响应。实现控制和实时显示(上升、下降状态、当前处于哪一层、在哪一层停止等信息)。
2.电源接通后,若有人按下某一层的按键,它就会在相应的那一层停止4秒钟,并伴有开门和关门的声音提示。
 
关键词:AT89S51;按键扫描;数码管显示;电梯控制;

   Abstract
With the development of China's economy, the city has emerged more and more high-rise buildings, and with the ancillary elevator has become an indispensable tool in daily life. At the same time, due to the problem of national aging prominent, low-rise residential buildings (usually about 5 layers) also use the requirements of the elevator. Therefore, the study of elevator control in modern society has a very important role, as an electric professional students, these are the automation of professional learning content, but also their own interests. In order to better work later and more in-depth understanding of the elevator control system based on single-chip, so the choice of the subject.
This topic is a five-story passenger elevator simulation control system, which has the following functions:
1. The two elevators are controlled by a set of keys, and when one presses the button, the idle elevator responds, and if the two elevators are in an idle state, the two elevators respond at the same time. To achieve control and real-time display (rising, falling state, which layer is currently in which layer to stop and other information).
2. When the power is turned on, if someone presses a layer of the button, it will stop in the corresponding layer of 4 seconds, accompanied by open and close the door of the voice prompts.
 
Key words: AT89S51; key scan; digital tube display; elevator control;
 
 
 

 
 
 
 
 
 
 
 
 
 
 
基于单片机电梯控制系统 I
摘  要 I
关键词: I
1 前言 2
1.1  课题的提出及研究意义 2
1.2  国内外电梯系统技术的发展现状 3
1.3  课题研究的内容 5
2  方案论证 6
2.1 主控芯片选择 6
2.2  定位平层模块 6
2.3  楼层显示模块 7
2.4  声音提示模块 7
2.5  电动机模块 7
2.6 电动机驱动模块 8
3 硬件设计 9
3.1 总体方案设计 9
3.2 单片机最小系统 10
3.3各模块设计 11
3.3.1  按键电路 11
3.3.2 显示电路 11
3.3.3 电机正反转指示 12
3.3.4  电源模块 12
3.3.5  红外发射接收电路 13
3.3.6  电机驱动电路 13
3.3.7 按键指示 14
3.3.8  紧急报警 14
4 软件设计 16
4.1 电梯主程序 16
4.2 电梯逻辑控制 17
4.3 电梯运行控制 18
4.3  键盘扫描、楼层检测 19
4.4  紧急停止、演示功能 20
4.5  程序中位操作问题分析 20
5 系统测试 21
5.1 软件编译调试 21
5.2 硬件仿真 22
5.4 系统测试 22
5.4.1方向优先测试 22
5.4.2  距离优先测试 23
5.4.3  综合测试 23
5.4.4  演示测试 23
6 小结与展望 25
参考文献 26
致谢 27
附录一:程序代码 28
附录二:系统PCB图 40
附录四:电梯模拟实物图 42
  资料目录与使用说明咨询微信号:biyezuopinvvp QQ:1015083682     返回首页 如转载请注明来源于www.biyezuopin.vip  

                 

打印本页 | 关闭窗口
  下一篇文章:电梯控制系统设计任务书
本类最新文章
基于STC89C51单片机的多波 … 基于DDS技术的多功能信号发生器 … 基于STM32F103C8T6的 …
基于西门子S7-200PLC的变 … 基于STM32单片机的的语音控制 … 基于PLC的小型自动化分生产线控 …
| 关于我们 | 友情链接 | 毕业设计招聘 |

Email:biyeshejiba@163.com 微信号:biyezuopinvvp QQ:1015083682  
本站毕业设计和毕业论文资料均属原创者所有,仅供学习交流之用,请勿转载并做其他非法用途.如有侵犯您的版权有损您的利益,请联系我们会立即改正或删除有关内容!